Visit us at the 86th Motor Show

Experience live our new products at the international Motor Show
in Geneva. We are looking forward to your visit!

03.03. - 13.03.2016 | Hall 7 | Stand 7413


Common Rail High Pressure Tester "JM"

The high pressures in the common rail system, which usually exceed 1000 bar, make it difficult to measure the actual pressure. Most common available testers measure the pressure based on the signal from the pressure sensors of the vehicle. If the pressure sensors are defective or incorrectly adjusted, can it happen that incorrect values are read off. This common rail tester measures the actual pressure with an analog 2000 bar pressure gauge. The gauge is made of stainless steel.


  • The tester is supplied with two different sets of flexible hoses and adapters so that the tester can be used universally.
  • Due to the relief valve (1400 bar), can the pressure also be tested directly on the pump.


      more ...


      Cap Nut Set "JM" 12-pcs.

      The set consists of 6 caps each M 12x1.50 and M 14x1.50 with internal thread and sealing cone.

      • also suitable for just sealing against pollution


      more ...


      Common Rail Dummy Regulator Set "JM" 9-pcs.

      To close the regulator hole in the common-rail high-pressure pump in order to determine if the faulty part is the regulator or the pump.


      more ...


      03.03. - 13.03.2016

      to the fair …

      Auf einen Klick..